Starting A Program; Venting; Sterilization / Autoclaving; Cooling Down - End Of Cycle - Acoustic Signal - CertoClav MultiControl 2 Bedienungsanleitung

Manual_MC2_DE_EN_V2.docx

Starting a program

Select a sterilization program in the control unit and push start.

Venting

If venting is activated, then the sterilization chamber is vented at 115°C for 10 minutes.

Sterilization / Autoclaving

For long time cycles close the cock. Remove the seal to enable this. This does NOT lead to a
loss of warranty. The seal is only for process quality control in sterilization processes where
the cock must not be closed.
Cooling down – end of cycle – acoustic signal
As the last step the controller cools down the autoclave to 80°C or 70°C for liquid program.
Thereafter an acoustic signal sounds and the controller displays "program finished".
The autoclave can now be opened.
If your application should require a faster cool down process, you can release the pressure
via the steam release cock. Obey safety remarks.

Opening


Turn red knob of locking to open = unlock. Steam release valve will be opened.
Steam escapes.

Turn lid anticlockwise and remove.

To get better drying of the loading remove the basket from the chamber and let it cool
down to room temperature before taking goods out.

Should the cycle interrupted caused by switch off or electrical failure or other reason –
the sterilization is not competed correct and has to be repeated. For opening please
follow the safety remarks for cooling down.
CertoClav Sterilizer GmbH
Georg Grinninger-Str. 37
A-4050 Traun / Austria
www.certoclav.com support@certoclav.com
Page 18 of 44