Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Zip HydroTap
SPARKLING und BCS 120 / 125
®
6. Cleaning and Maintenance
B ( 2 : 1 )
7
6
5
7
6
5
Downloaded from
www.Manualslib.com
Cleaning
The plastic surfaces and taps should only be wiped with a damp cloth. Do not use
abrasive or chlorine-based cleaning agents or solvents.
Do not clean the undersink unit and tap with a water jet, as that could damage the
electronic components.
CO
Bottle Replacement
2
If the carbon dioxide gas bottle is empty, replace it as follows:
1. Close the red lever on the pressure reducer
4
3
2
2. Turn the pressure adjusting screw on the pressure reducer anticlockwise as far as it
will go (no pressure).
3. Replacing the carbon dioxide gas bottles:
a. Gas bottle with self closing valve:
Gas bottle
- Unscrew the gas bottle from the pressure reducer.
with self closing valve
- Remove the gas bottle and secure the new gas bottle in place on the holder so
- Quickly screw the new, full gas bottle into the pressure reducer, as far as it will
b. Gas bottle with hand weel:
- Close the shut-off valve on the gas bottle.
- Undo the union nut connecting the gas bottle to the pressure reducer.
- Remove the gas bottle and secure the new gas bottle in place on the holder so
Gas bottle with
hand weel
- Connect the pressure reducer to the new, full gas bottle. Tighten the union nut
DATUM
Name
Gezeichnet
16.07.2014
ruecker
Kontrolliert
Norm
Zeichnung Gasflaschenkopf
Status
Änderungen
DATUM
Name
4
3
4. Set a delivery pressure of 2.7 bar on the pressure reducer of the carbon dioxide
2
gas bottle. Turn the adjusting screw anticlockwise to reduce the pressure. Turn it
clockwise to increase the pressure.
5. Open the red lever on the pressure reducer
6. Check the gas-carrying connections for leaks. Caution - gas released can be very cold.
Use a leak detecting spray or soapy water so that even minor leaks will be detected.
Please note that the room where a carbon dioxide gas bottle is placed must
have a minimum room volume of 38 m
Note: The carbon dioxide gas bottle must always be used in the upright posi-
tion to ensure that the pressure reducer operates correctly and thus ensure the
safety of the unit.
Note: The carbon dioxide gas bottle must not be exposed to temperatures high-
er than 35°C. Cooling should be provided if necessary.
manuals search engine
1
F
E
that it cannot topple over.
D
go.
C
B
that it cannot topple over.
moderately tight.
A
1
A2
1
26
3
for every kg of bottle capacity.
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
