Troubleshooting - clage Zip HydroTap SPARKLING Gebrauchs- Und Montageanleitung

Zip HydroTap SPARKLING und BCS 120 / 125
®

7. Troubleshooting

If a problem occurs with your Zip HydroTap unit, the cause is often something very simple. Try to resolve the problem yourself with the
aid of the table below. That will help you avoid the expense of an unnecessary call-out.
Problem
No LED display and no
water flows when tap is
operated.
No water flow when tap is
operated.
Unit is slow to refill after
drawing water.
Water not hot.
Water not cold.
All LEDs are flashing.
If you cannot rectify the fault with the aid of this table, please contact:
CLAGE GmbH
Central Customer Service
Pirolweg 1 – 5
21337 Lüneburg
Germany
Tel: +49 · 4131 · 89 01-40
Fax: +49 · 4131 · 89 01-41
Email: service@clage.de
Downloaded from www.Manualslib.com
Cause
No power.
Tap is not connected to undersink unit.
Possible internal fault.
No water.
Tap is not connected to the undersink unit.
Water is not at boiling temperature.
Filter blocked.
Unit is in Sleep mode.
Possible internal fault.
Very frequent use.
Possible internal fault.
Power interruption.
Water interruption.
Possible internal fault.
manuals search engine
Remedy
Check power supply.
Check plug connection between tap and
undersink unit.
Contact customer service.
Check water supply.
Check hoses between tap and undersink unit.
Wait for water to reach boiling temperature.
Check whether the white LED is flashing,
indicating that the filter needs to be replaced.
Press red lever and wait for red LED to show a
steady light.
Contact customer service.
Wait for the blue LED to show a steady light.
Contact customer service.
Switch off unit, wait 15 minutes and then
switch on again.
Check water inlet for blockages.
Contact customer service.
28