Safety Instructions - GUTMANN VIENTO Montageanleitung

EN

Safety instructions

Installation, connection, commissioning and repair may only be carried out by a qualifi-
ed person. This specialist can determine the suitable attachment of the trough fan. The
fastening must be suitable for the weight of the hob extractor hood and the load on the
substrate. In the case of other unsafe substrates, a specialist in building matters, e.g.
a structural engineer or architect, must be consulted for the safe installation of the
trough ventilator.
Risk of injury !
Sharp edges may be present in the hob extractor hood due to the manufacturing pro-
cess. Wear protective gloves during assembly !
Danger of electric shock !
The mains voltage must correspond to the specifications on the nameplate. The fixed
connection may only be connected to the mains voltage by a qualified electrician. For
the fixed connection, the hob extractor hood must be connected to an individual circuit
with isolating device. Switches with a contact opening of at least 3 mm and all-pole
switches, e.g. LS switches and contactors, are regarded as disconnecting devices. Be-
fore working on the electrical connection of the hob extractor hood, switch off the mains
circuit(s). Before drilling fixing holes, check that no electrical cables can be damaged
by drilling. The electrical connection must be prepared so that the skip ventilation can
be easily connected. Local regulations must be observed.
Transport, unpacking, installation
Condensation may occur if the appliance is brought into the installation site from a
cold environment. Please wait until the appliance has adjusted to the temperature and
is completely dry before operating it. The acclimatization period depends on the tempe-
rature difference and the type and design of the appliance. However, it should be at
least 12 hours.
Please wear protective gloves during installation to avoid the risk of injury. Prepare any
tools required before mounting the hob extractor hood.
For the assembly of the hob extractor hood, the customer must provide the necessary
conditions for a smooth assembly of the hob extractor hood, cover kitchen appliances.
19