Software Update; Installation Of The Software; Installing The Driver - JB-Lighting Varyscan 7 Bedienungsanleitung

5.6 Software update us JB-lighting Upgrade-Dongle
5.6.1 Check the items supplied/The package contains
* JB-lighting Upgrade-Dongle
* 3,5" floppy disc with software
* USB cable
* DMX cable, 5pins (all pins occupied)
5.6.2 Info
Before using the upgrade-dongle install the software.
The procedure to install the software differs according to the OS.
Follow the procedure to install below for the OS in your machine. The example
below might be a little bit different to the way the OS in your computer works.
The software works with Windows 98, XP und 2000

5.6.3 Installation of the software

1. Insert the floppy disc into floppy-disc drive of your computer
2. Use the explorer to open drive A:
3. Open file Setup.exe (double-click. )
4. That starts up the installation program --> follow the on-screen instruction to complete the
installation of the program file.

5.6.4 Installing the driver

1. Connect the upgrade-Dongle with the USB port of your computer.
2. The installation program will be activated -->follow the on-screen instruction to continue
the installation.
3. IMPORTANT :
Select: install driver manually, because automatical driver-installation will not work.
4. After choosing "manual installation", select drive A:\Driver .
5. Confirm selected driver and complete installation.
There might be the message "Driver not digitally signed" show on your computer monitor,
if the driver is installed on OS Windows XP.
Complete the installation anyway, because the driver will work with the Upgrade-Dongle
without problems.
5.6.5 Updating the fixture
1. Disconnect fixture from mains and remove both DMX cables.
2. Connect the upgrade-Dongle to the fixture (use the DMX cable which comes together
with the dongle only! Upgrade-Dongle DMX-out / fixture: DMX-in)
Connect the USB cable with the USB port of your computer.
3. Recall the program-start of you computer and select the program for the Upgrade-Dongle.
4. Press MENU key of your fixture and hold it.
5. Connect the fixture to mains again. There will be a message on the monitor displaying a
connected fixture and an additional menu will be shown.
6. Choose the desired file on your computer.
7. Start the update procedure by selecting "open"
8. After completing the update the message "Update complete" will be displayed on the
computer and the fixture will reset.
JB-lighting Lichtanlagentechnik GmbH Sallersteigweg 15 D-89134 Blaustein Telefon +49 (0)7304-9617-0
33