Handling The Remote Controller; Replacing Batteries - Kaisai KPPH-09HRN29 Bedienungsanleitung

Handling the remote controller

Handling the remote controller
8m 8m
CAUTIONS CAUTIONS
The air conditioner will not operate if curtains, doors or other materials The air conditioner will not operate if curtains, doors or other materials
block the signals from the remote controller to the indoor unit. block the signals from the remote controller to the indoor unit.
Prevent any liquid from falling into the remote controller. Do not expose Prevent any liquid from falling into the remote controller. Do not expose
the remote controller to direct sunlight or heat. the remote controller to direct sunlight or heat.
If the infrared signal receiver on the indoor unit is exposed to direct If the infrared signal receiver on the indoor unit is exposed to direct
sunlight, the air conditioner may not function properly. Use curtains to sunlight, the air conditioner may not function properly. Use curtains to
prevent the sunlight from falling on the receiver. prevent the sunlight from falling on the receiver.
If other electrical appliances react to the remote controller. either move If other electrical appliances react to the remote controller. either move
these appliances or consult your local dealer. these appliances or consult your local dealer.

Replacing batteries

Replacing batteries
. .
Location of the remote controller. Location of the remote controller.
Use the remote controller within a distance of 8 Use the remote controller within a distance of 8
meters from the appliance, pointing it towards the meters from the appliance, pointing it towards the
receiver. Reception is confirmed by a beep. receiver. Reception is confirmed by a beep.
The remote controller is powed by two dry The remote controller is powed by two dry
batteries(R03/LR03X2) housed in the rear batteries(R03/LR03X2) housed in the rear
part and protected by a cover. part and protected by a cover.
(1) Remove the cover by pressing and sliding off. (1) Remove the cover by pressing and sliding off.
(2) Remove the old batteries and insert the new (2) Remove the old batteries and insert the new
batteries,placing the(+) and (-) ends correctly. batteries,placing the(+) and (-) ends correctly.
(3) Reattach the cover by sliding it back into (3) Reattach the cover by sliding it back into
position. position.
NOTE: When the batteries are removed, the NOTE: When the batteries are removed, the
remote controller erases all programming. remote controller erases all programming.
After inserting new batteries, the remote After inserting new batteries, the remote
controller must be reprogrammed. controller must be reprogrammed.
2 2
67
EN