Remote Controller Specifications; Handling The Remote Controller - Kaisai KCA3U-12 Bedienungsanleitung

Remote Controller Specifications

RG10A(B2S)/BGEF, RG10A(B2S)/BGEFU1,
RG10A(F2S)/BGEF, RG10A(F2S)/BGEFU1,RG10A1(F2S)/BGEF,
RG10A2(F2S)/BGEFU1, RG10A2(F2S)/BGCEFU1, RG10A2(F2S)/BGCEF,
RG10A1(B2S)/BGEF,RG10A2(B2S)/BGEFU1,
RG10A10(F2S)/BGEF, RG10A(H2S)/BGEF, RG10A(H2S)/BGEFU1,
RG10A2(B2S)/BGCEFU1, RG10A2(B2S)/BGCEF,
RG10A1(H2S)/BGEF, RG10A2(H2S)/BGEFU1, RG10A2(H2S)/BGCEFU1,
Model
RG10A2(H2S)/BGCEF, RG10A10(H2S)/BGEF, RG10A(G2S)/BGEF,
RG10A10(B2S)/BGEF.
RG10A(G2S)/BGEFU1,RG10A1(G2S)/BGEF,RG10A2(G2S)/BGEFU1,
RG10A2(G2S)/BGCEFU1, RG10A2(G2S)/BGCEF, RG10A10(G2S)/BGEF .
3.0V( Dry batteries R03/LR03×2)
Rated Voltage 3,0 V (Dry batteries R03/LR03×2)
8m
Signal Receiving Range 8 m
-5°C~60°C(23°F~140°F)
Environment
-5°C~60°C(23°F~140°F)
Quick Start Guide
1 2
AUTO
COOL
DRY
HEAT
FAN
FIT BATTERIES SELECT MODE
6 5
PRESS POWER BUTTON POINT REMOTE TOWARD UNIT
NOT SURE WHAT A FUNCTION DOES?
Refer to the How to Use Basic Functions and How to Use Advanced Functions sections
of this manual for a detailed description of how to use your air conditioner.
SPECIAL NOTE
Button designs on your unit may differ slightly from the example shown.
•
If the indoor unit does not have a particular function, pressing that function's button on
•
the remote control will have no effect.
When there are wide differentces between "Remote controller Manual" and "USER'S
•
MANUAL" on function description, the description of "USER'S MANUAL" shall prevail.
3
SELECT TEMPERATURE
4
AU-100%
SELECT FAN SPEED
48

Handling the Remote Controller

Inserting and Replacing Batteries
Your air conditioning unit may come with two
batteries(some units). Put the batteries in the
remote control before use.
Slide the back cover from the remote control
1.
downward, exposing the battery compartment.
Insert the batteries, paying attention to match
2.
up the (+) and (-) ends of the batteries with
the symbols inside the battery compartment.
3. Slide the battery cover back into place.
BATTERY NOTES
For optimum product performance:
• Do not mix old and new batteries, or
batteries of different types.
• Do not leave batteries in the remote control
if you don't plan on using the device for more
than 2 months.
BATTERY DISPOSAL
Do not dispose of batteries as unsorted
municipal waste. Refer to local laws for proper
disposal of batteries.
TIPS FOR USING REMOTE CONTROL
• The remote control must be used within 8
meters of the unit.
The unit will beep when remote signal is
•
received.
Curtains, other materials and direct sunlight
•
can interfere with the infrared signal receiver.
Remove batteries if the remote will not be
•
used more than 2 months.
NOTES FOR USING REMOTE CONTROL
The device could comply with the local national
regulations.
In Canada, it should comply with
•
CAN ICES-3(B)/NMB-3(B).
In USA, this device complies with part 15 of the
•
FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference,
and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses and
can radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct
the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment
and receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV
technician for help.
Changes or modifications not approved by the
party responsible for compliance could void
user's authority to operate the equipment.
49