Herunterladen Inhalt Inhalt Diese Seite drucken

The Timer; Setting/Changing The Time; Semi-Automatic And Fully Automatic Operation - hanseatic 10143.3eETsPrDpHaJXSp Gebrauchsanleitung

Einbau-backofen mit zeitschaltuhr und pyrolyse
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

The timer

Setting/changing the time

Setting the time
During initial commissioning or after a power
failure, the display flashes '
cates that the time must be set.
Please note: The following steps must be
carried out one after the other. The process
stops if there is a pause longer than 7 sec-
onds.
1. Press the 'OK' button once.
The display shows the symbol ' ', the dot
underneath flashes.
2. Set the time using the arrow buttons '<' or '>'.
Shortly after the last keystroke, the dot stops
flashing. The time is now saved.
Changing the time
This is necessary e.g. when changing to and
from summer time.
Requirements:
– The timer switch must not be in automatic
mode and
– the countdown timer must not be active.
1. Press the two arrow keys '<' and '>' simul-
taneously.
The dot beneath the symbol ' ' flashes.
2. Set the time using the arrow buttons '<' or '>'.
To quickly go forwards/backwards,
hold the corresponding button down.
Semi-automatic and fully
automatic operation
WARNING
'. This indi-
Please ensure that you always observe
the following when using the automat-
ic timer:
Please make sure to inform all mem-
bers of the household so that they do
not put anything in the oven.
Monitor the oven in order to prevent
spills and burning.
Take special care when roasting: Fat,
oil and alcohol can ignite.
Never leave anything to grill unat-
tended when using the timer!
The timer does not control the switch-
ing on and off of the hob.
After use, set the function selector and
the temperature controller to »0«.
All settings will be deleted in the case
of a power failure.
The correctly set time is a prerequisite.
– You can pre-programme up to 23 hours
and 59 minutes in advance.
– The cooking time can be set between 1
minute and 10 hours.
– Any programming will be deleted in the
case of a power failure.
– A tone sounds to signal the end of the pro-
gramme, which you can cancel by pressing
any button.
Page EN-21
The timer

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis