Mode Setup - Snap-On TECHANGLE ATECH1FR240B Bedienungsanleitung

Note: All user configurable settings are stored in non-volatile memory and are retained while power
is off.

Mode Setup

Mode setup menu allows user to enable/disable Torque THEN angle mode.
1. From Configure menu, press ENTER
2. Mode Setup menu is displayed.
Menu Selections:
 EXIT - Exits Mode setup menu and returns to Configure menu screen.
 THEN DISABLED - Displays THEN Mode enable/disable screen.
3. Use UP /DOWN



4. Press ENTER button while

EXIT
MODE SETUPs
CALIBRATION
SET DATE/TIME
Configure menu
Enable/Disable Torque THEN Angle Mode
This function will allow user to enable or disable Torque THEN Mode.
1. From Mode Setup menu, use UP
(factory default) then press ENTER
2. TQ THEN ANGLE enable/disable screen is displayed.
3. Use UP  /DOWN


4. Press ENTER button to accept selection and exit to Mode Setup menu.

EXIT
THEN DISABLED
Note: Menu selection indicates current configuration (ENABLED or DISABLED).
Torque THEN Angle Mode
Torque THEN Angle mode is setup by first setting a target torque and units then a target angle before
selecting Torque THEN Angle mode. In Torque THEN Angle mode, when applied torque reaches
target torque, wrench automatically switches to angle mode for angle measurement. Progress lights
indicate applied torque progress while torque is measured and angle when angle is measured.
1. From target torque screen, use UP
button to select torque measurement units then press ENTER
2. Angle target screen is displayed. Use UP

ENTER button.

3. Torque THEN Angle mode screen is displayed.
4. Apply torque until target is reached then rotate wrench to target angle.

button while

buttons to highlight menu selections.

EXIT menu selection is highlighted to return to Configure menu.
ENTER EXIT
button
THEN DISABLED
Mode Setup menu
/DOWN



button.

 buttons to select ENABLE or DISABLE selection.
TQ THEN ANGLE
ENTER
button
ENABLE
DISABLE
UP/DOWN buttons
TQ THEN ANGLE
ENABLE
DISABLE

MODE SETUP
buttons to highlight

ENTER
EXIT
button
THEN DISABLED
ENTER EXIT
button
THEN ENABLED
/DOWN  buttons to set target torque and UNITS

 /DOWN  buttons to set target angle then press

16
selection is highlighted.
THEN DISABLED

button.

selection
U