Snap-On TECHANGLE ATECH1FR240B Bedienungsanleitung Seite 15

EXIT
SHOW INFO
SLEEP TIME
LCD CONTRAST
UP/DOWN buttons
SLEEP TIME
LCD CONTRAST
KEY BEEP
AUTO BACKLIGHT
ENTER
button
Toggle Backlight Setup
This function will allow user to enable or disable backlight toggle function. If toggle mode is disabled,
BACKLIGHT button turns on backlight and it automatically turns off after five seconds following
any last button press. If toggle mode is enabled, a BACKLIGHT
and it will remain on until next BACKLIGHT
1. From Settings menu, use UP
then press ENTER
2. TOGGLE BACKLGHT screen is displayed.
3. Use UP  /DOWN


4. Press ENTER button to accept selection and exit to Settings menu.

EXIT
SHOW INFO
SLEEP TIME
LCD CONTRAST
UP/DOWN buttons
LCD CONTRAST
KEY BEEP
AUTO BACKLIGHT
TOGGLE BACKLGHT
Note: Backlight will turn off when wrench powers down either by POWER
time.
Note: If toggle backlight is enabled and backlight is on, backlight will remain on during and after
applying torque.
AUTO BACKLIGHT
ENTER
button
ENABLE
DISABLE
UP/DOWN buttons
AUTO BACKLIGHT
ENABLE
DISABLE
/DOWN



button.

 buttons to highlight ENABLE or DISABLE (factory default) selection.
TOGGLE BACKLGHT
ENTER
button
ENABLE
DISABLE
TOGGLE BACKLGHT
ENABLE
DISABLE
ENTER
button
button press.
buttons to highlight

UP/DOWN buttons
14
button press will turn on backlight
TOGGLE BACKLGHT
q button press or sleep
selection