Snap-On TECHANGLE ATECH1FR240B Bedienungsanleitung Seite 11

5. MAXIMUM TORQUE or ANGLE screen is displayed next . Value can be changed by pressing UP
/DOWN  buttons. Once desired target torque or angle value has been set, press


ENTER button.

6. BATCH COUNT screen is displayed next. Value can be changed by pressing UP
buttons. Once desired batch count value has been set, press ENTER
7. PSET target screen is displayed labeled with same PSET number.
PSET 02 00
90
DEG
Preset Angle Screen
PSET 02 00
92
DEG
Preset Angle Screen
Note: Pressing ENTER
PSET.
Deleting a Preset
Delete PSET function allows user to remove stored presets from wrench.
1. From Preset screen to be deleted, press and hold UNITS
2. CHANGE PRESET screen is displayed.
3. Highlight DELETE
4. Target screen is displayed and deleted PSET is no longer available for selection.
PSET 02
92
DEG
Preset Angle Screen
100.0
FT-LB
Target Screen
Note: Pressing ENTER
PSET.
Note: When a PSET is deleted, all other stored PSET's will retain their original PSET numbers. When
a new PSET is entered, it will be assigned first available PSET number in sequence.
UNIT
CHANGE PRESET
button
DELETE
held
EDIT
EXIT
UP/DOWN buttons
CHANGE PRESET
DELETE
EDIT
EXIT
ENTER button

button while

menu selection using UP
UNIT
00
CHANGE PRESET
button
DELETE
held
EDIT
EXIT
UP/DOWN buttons
CHANGE PRESET
DELETE
EDIT
EXIT
00
ENTER button

button while

ENTER
button
MINIMUM ANGLE
92
EXIT menu selection is highlighted will exit without editing
U
 /DOWN 
 
ENTER button
EXIT menu selection is highlighted will exit without deleting
10

button.

UP/DOWN buttons
ENTER
MAXIMUM ANGLE
button
94
DEG
BATCH COUNT
0
button for 3 seconds.
buttons and press ENTER


 /DOWN 
 
UP/DOWN buttons
DEG
ENTER
button
UP/DOWN buttons

button.
