Snap-On TECHANGLE ATECH1FR240B Bedienungsanleitung Seite 10

Note: To select a stored PSET or manual target torque or angle mode, repeatedly press ENTER
button until desired PSET or manual mode is displayed.
Adding an Angle Preset
1. From target angle screen, press and hold UNITS
2. ADD PRESET confirmation screen is displayed. Highlight
 buttons then press ENTER

adding a PSET.
3. MINIMUM ANGLE screen is displayed. MINIMUM ANGLE is target value at which green progress
lights, audible alert and vibrator turn on. Initial MINIMUM ANGLE value is value from target angle
screen. MINIMUM ANGLE can be set from 0 to 360° by pressing UP
desired target angle value has been set, press ENTER
4. MAXIMUM ANGLE screen is displayed next. MAXIMUM ANGLE is angle value above which red
progress lights turn on. Initial MAXIMUM ANGLE value will be MINIMUM ANGLE plus 4%.
Maximum angle value can be set to any value greater than MINIMUM ANGLE by pressing
UP /DOWN
 

5. BATCH COUNT screen is displayed next. Default value is zero. Batch count range is 0 to 99. Press
UP /DOWN


time target angle is reached if a batch count of zero is entered. Mode Count decrements if a non-
zero batch count is entered and resets to batch count value when count reaches zero. Once
desired value has been set, press ENTER
6. PSET target screen is displayed labeled with next available PSET number from 01 to 10.
7. To enter additional angle presets, repeatedly press ENTER
displayed and repeat steps above.
00
90
DEG
Target Angle Screen
ENTER button
PSET 02 04
90
DEG
Preset Angle Screen
Note: To select a stored PSET or manual target torque or angle mode, repeatedly press

ENTER button until desired PSET or manual mode is displayed.

Editing a Preset
Edit PSET function gives user ability to edit stored PSETS on wrench.
1. From Preset screen to be edited, press and hold UNITS
2. CHANGE PRESET screen is displayed.
3. Highlight EDIT selection using UP
4. MINIMUM TORQUE or ANGLE screen is displayed. Value can be changed by pressing UP
/DOWN  buttons. Once desired target torque or angle value has been set, press ENTER
button.


buttons. Once desired value has been set, press ENTER

buttons to increment/decrement batch count. Mode Count increments each

UNIT
ADD PRESET
button
held
YES
NO
UP/DOWN buttons
ADD PRESET
YES
NO
 /DOWN

U button for 3 seconds.
button. NO menu selection returns to main menu without



button.

UP/DOWN buttons
ENTER
button
MINIMUM ANGLE
90
ENTER button
U
 buttons then press ENTER

9
YES menu selection using UP
/DOWN


button.


button until target angle screen is

ENTER
button
MAXIMUM ANGLE
94
DEG
BATCH COUNT
4
button for 3 seconds.



/DOWN


buttons. Once


button.

UP/DOWN buttons
DEG
ENTER
button
UP/DOWN buttons
button.




