Pelgrim IDK832 Anleitung Seite 107

troubleshooting
Symptom
The hob is not working
and nothing appears in the
display.
A fuse blows as soon as the
hob is switched on.
Error code ER22.
Error code F0 up to and
including F6 and FC.
Error code E2.
Error code U400.
Error code
.
Other error codes.
Possible cause
There is no power supply
due to a defective cable or a
faulty connection.
The hob has been wrongly
connected.
The control panel is dirty or
has water lying on it.
Defective generator.
Appliance over heated.
The appliance has been
connected incorrectly and/or
the mains voltage is too high.
You touched and hold a
button too long.
Defective generator.
Solution
Check the fuses or the
electric switch (if there is no
plug).
Check the electrical
connections.
Clean the control panel.
Contact the service
department.
The appliance has been
switched off because of over
heating. Let the appliance
cool down and start again on
a lower setting.
Let your connection be
changed.
Do not hold and touch the
button too long.
Contact the service
department.
GB 23