Electrolux EWN 148640 W Benutzerinformation Seite 27

Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the ma-
chine is not impeded by carpets, rugs etc.
Check that the machine does not touch the
wall or other kitchen units. Level the wash-
ing machine by raising or lowering the feet.
The feet may be tight to adjust as they incor-
porate a self locking nut, but the machine
MUST be level and stable. If necessary,
check the setting with a spirit level. Any nec-
essary adjustment can be made with a span-
ner. Accurate levelling prevents vibration,
noise and displacement of the machine dur-
ing operation.
Caution! Never place cardboard,
wood or similar materials under the
machine to compensate for any
unevenness in the floor.
Water inlet
An inlet hose is supplied and can been
found inside the machine drum. Do not use
the hose from your previous machine to con-
nect to the water supply.
Important! This appliance must be con-
nected to a cold water supply.
1. Open the porthole and extract the inlet
hose.
2. Connect the hose with the angled con-
nection to the machine. Do not place
the inlet hose downwards. Angle the
hose to the left or right depending on
the position of your water tap.
3. Set the hose correctly by loosening the
ring nut. After positioning the inlet hose,
be sure to tighten the ring nut again to
prevent leaks.
electrolux 27