What To Do If - Electrolux EWN 148640 W Benutzerinformation

22 electrolux
6. When you intend to start the machine
up again, make sure that the room tem-
perature is above 0°C.

WHAT TO DO IF...

Certain problems are due to lack of simple
maintenance or oversights, which can be
solved easily without calling out an engi-
neer. Before contacting your local Service
Centre, please carry out the checks listed
below.
During machine operation it is possible that
the red pilot light of button 7 blinks, one of
the following alarm codes appears on the
display and some acoustic signals sound ev-
ery 20 seconds to indicate that the machine
is not working:
• Problem with the water supply: « Cannot
fill water. Please check that the tap is
open and then press START/PAUSE ».
Problem
The machine does not start:
The machine does not fill:
• Problem with the water draining: « Can-
• Door open: « Please check that the door
Once the problem has been eliminated,
press the button 7 to restart the pro-
gramme. If after all checks, the problem per-
sists, contact your local Service Centre.
Possible cause/Solution
The door has not been closed. (« Please check that the door is
closed properly and then press START/PAUSE »)
• Close the door firmly.
The plug is not properly inserted in the power socket.
• Insert the plug into the power socket.
There is no power at the socket.
• Please check your domestic electrical installation.
The main fuse has blown.
• Replace the fuse.
The selector dial is not correctly positioned and the button 7 has
not been pressed.
• Please turn the selector dial and press the button 7 again.
The delay start has been selected.
• If the laundry are to be washed immediately, cancel the delay start.
The Child Safety Lock has been activated.
• Deactivate the Child Safety Lock.
The water tap is closed. (« Cannot fill water. Please that the
tap is open and then press START/PAUSE »)
• Open the water tap.
The inlet hose is squashed or kinked. (« Cannot fill water.
Please that the tap is open and then press START/PAUSE »)
• Check the inlet hose connection.
The filter in the inlet hose is blocked. (« Cannot fill water. Please
that the tap is open and then press START/PAUSE »)
• Clean the water inlet hose filter.
The door is not properly closed. (« Cannot fill water. Please
that the tap is open and then press START/PAUSE ») (« Can-
not fill water. Please that the tap is open and then press
START/PAUSE »)
• Close the door firmly.
not drain the water. Please check that
the filter is clean and then press START/
PAUSE ».
is closed properly and then press START/
PAUSE
».