Electrolux EWN 148640 W Benutzerinformation Seite 23

Problem
The machine does not emp-
ty and/or does not spin:
There is water on the floor:
Unsatisfactory washing re-
sults:
The door will not open:
The machine vibrates is
noisy:
Possible cause/Solution
The drain hose is squashed or kinked. (« Cannot drain the wa-
ter. Please check that the filter is clean and then press
START/PAUSE »)
• Check the drain hose connection.
The drain filter is clogged. (« Cannot drain the water. Please
check that the filter is clean and then press START/
PAUSE »)
• Clean the drain filter.
An option or a programme that ends with the water still in the tub
or a that eliminates all the spinning phases has been selected.
• Select the draining or spinning programme.
The laundry is not evenly distributed in the drum.
• Redistribute the laundry.
Too much detergent or unsuitable detergent (creates too much
foam) has been used.
• Reduce the detergent quantity or use another one.
Check whether there are any leaks from one of the inlet hose fit-
tings. It is not always easy to see this as the water runs down the
hose; check to see if it is damp.
• Check the water inlet hose connection.
The drain or inlet hose is damaged.
• Replace it with a new one.
The emergency emptying cap has not been replaced into the filter
or the filter has not been properly screwed in after cleaning action.
• Refit the emergency emptying cap or screw the filter fully in.
Too little detergent or unsuitable detergent has been used.
• Increase the detergent quantity or use another one.
Stubborn stains have not been treated prior to washing.
• Use commercial products to treat the stubborn stains.
The correct temperature was not selected.
• Check if you have selected the correct temperature.
Excessive laundry load.
• Reduce the laundry load.
The programme is still running.
• Wait the end of washing cycle.
The door lock has not been released.
• Wait for the Door icon
pearing.
There is water in the drum.
• Select drain or spin programme to empty out the water.
The transit bolts and packing have not been removed.
• Check the correct installation of the appliance.
The support feet have not been adjusted
• Check the correct levelling of the appliance.
The laundry is not evenly distributed in the drum.
• Redistribute the laundry.
Maybe there is very little laundry in the drum.
• Load more laundry.
and the corresponding message ap-
electrolux 23