Bluetooth - Yamaha MusicCast WX-010 Bedienungsanleitung

Bluetooth

Problem
Cannot make this unit paired with
the connecting device.
Cannot establish a Bluetooth
connection.
No sound is produced or the
sound is interrupted during
playback.
Cause
The connecting device does not support A2DP.
The passkey of the devices, such as a Bluetooth
adaptor, that you want to pair with this unit is
other than "0000."
This unit and the connecting device are too far
apart.
There is a device (microwave oven, wireless
network, etc.) that outputs signals in the 2.4 GHz
frequency band nearby.
The unit is in standby.
Another Bluetooth device is connected.
The Bluetooth function of the unit is disabled.
This unit is not registered on the connecting
device's Bluetooth connection list.
The unit is in Eco Standby.
Another Bluetooth device is connected.
The Bluetooth function of the device is turned
off.
The pairing information has been deleted.
The Bluetooth connection of this unit with the
connecting device is disconnected.
This unit and the connecting device are too far
apart.
There is a device (microwave oven, wireless
network, etc.) that outputs signals in the 2.4 GHz
frequency band nearby.
The connecting device's Bluetooth function is
off.
The connecting device is not set to send
Bluetooth audio signals to this unit.
The pairing setting of the connecting device is
not set to this unit.
The connecting device's volume is set to the
minimum.
The connecting device is connected to more than
two Bluetooth devices and this unit (WX-010) is
not selected as a playback device.
20
TROUBLESHOOTING
Solution
Perform pairing operations with a device which
supports A2DP.
Use a connecting device with a passkey "0000."
Move the connecting device closer to this unit.
Move this unit away from the device that is emitting
radio-frequency signals.
Turn the unit on and perform pairing (☞ P.12).
Terminate current Bluetooth connection, and perform
pairing with the new device.
Enable the Bluetooth function of the unit
(☞ P.16).
Perform pairing operations again (☞ P.12).
Turn the unit on, then establish a Bluetooth
connection (☞ P.12).
Terminate current Bluetooth connection, then
establish a Bluetooth connection with that device
again.
Turn on the Bluetooth function of the device.
Delete any pairing history of WX-010 on the
Bluetooth device, then pair with the WX-010 again
(☞ P.12).
Perform Bluetooth connection operations again
(☞ P.12).
Move the connecting device closer to this unit.
Move this unit away from the device that is emitting
radio-frequency signals.
Turn on the Bluetooth function of the connecting
device.
Check that the Bluetooth function of the connecting
device is set properly.
Set the pairing setting of the connecting device to this
unit.
Increase the volume level.
Select this unit as a playback device for the
connecting device.