Preparation; Installation; Mounting The Unit On A Wall (Except For U.s.a. And Canada Model) - Yamaha MusicCast WX-010 Bedienungsanleitung

PREPARATION

Plug the power cable into the wall outlet after completing installation.
Note
• Placing the unit too close to a CRT TV may impair the picture color or cause a buzzing noise. In this case, move the unit at
least 20 cm (8") away from the TV. This is not an issue with LCD and plasma TVs.
• Install in a stable place, being careful of the following points:
– Do not place on top of steel or other metal plates.
– Do not cover with a cloth, etc.

Mounting the unit on a wall (Except for U.S.A. and Canada model)

You can mount the unit on the wall as follows.
Wall/wall support
A
Install screw (commercially available) into a solid wall or wall support as shown in the illustration. Use 3.5 to 4 mm (1/8")
diameter self-tapping screw.
B
Hang the unit by its keyhole slot onto the protruding screw.
Note
• Make sure the shaft of the screw is seated in the narrow part of the keyhole slot. Otherwise, the unit may fall.
• Do not mount the unit on thin plywood or on a wall with a soft surface material. Otherwise, the screw may pull out of the
surface and the unit may fall, possibly damaging the unit or causing personal injury.
• Do not affix the unit to a wall using nails, adhesives, or unstable hardware. Long-term use and vibration may cause the unit to
fall.
• To avoid accidents resulting from tripping over loose cables (such as a power cable), affix the cables to the wall.
• When using the brackets to mount the unit on a wall / ceiling, please use safety wire (not included) between the unit and the
bracket to prevent the unit from falling.
• If you are not sure of a safe way to install the unit, consult a professional installer or a building contractor.
• To prevent the vibration from the sound from reaching the wall, attach the Anti-vibration pads on the four corners of the rear
panel (☞ P.2).

INSTALLATION

B
A
5 mm
(1/4")
Minimum
20 mm (3/4")
WX-010
1.7 kg (3.7 lbs.)
4