Stereo Pair; Setting/Playing Back Music - Yamaha MusicCast WX-010 Bedienungsanleitung

OTHER FUNCTIONS AND INFORMATION
You can use two WX-010 units to reproduce stereo sound by setting each speaker as the right
or left speaker.
Set the left and right speakers separately by following the steps below.
WX-010
Left
speaker

Setting/Playing back music

A
Connect each WX-010 to the same network by using the dedicated app "MusicCast
CONTROLLER."
If the WX-010 is linked to another MusicCast unit, first disconnect the link by using the dedicated app "MusicCast
CONTROLLER."
B
Tap (power)/CONNECT of each unit to set them to standby.
C
Tap and hold the following together for 3 seconds to set the left/right speakers.
1 For setting the left speaker:
Indicators light from right to left repeatedly (refer to
of the table), and the unit enters pairing standby.
2 For setting the right speaker:
Indicators light from left to right repeatedly (refer to
of the table), and the units start pairing.
After paring is completed, the indicators light from the center to both sides (refer to
return to the normal status.
D
Use the dedicated app "MusicCast CONTROLLER" to play back.
y
• You can check which speaker is the left or right speaker with the dedicated app "MusicCast CONTROLLER" (Indicators
light as or of the table).
• In Stereo Pair mode, you can operate one speaker to simultaneously turn off both speakers or adjust the volume of both
speakers.
• If about five minutes passes while the unit cannot find the other speaker to connect to, the pairing standby will be cancelled
automatically.
• When in Stereo Pair mode, the option settings other than "Initialize the unit." (☞ P.16) cannot be set.
Note
The Stereo Pair setting remains even if the speakers enter standby or the power cable is unplugged and plugged again.

STEREO PAIR

WX-010
Right
speaker
and
Indicator display during the Stereo Pair
Stereo Pair
Start Pairing/
Checking the
Left and Right
and
Speaker
Pairing
Completed
14
Note
• To use the Stereo Pair function, you need two
WX-010.
• Stereo Pair is available only when the Network
Standby of the unit is enabled (☞ P.16).
Indicator display
status
Left speaker
Right-to-Left
Center to both sides
of the table), and all indicators
Right speaker
Left-to-Right