brose Display Remote Benutzerhandbuch Seite 29

Remote | Troubleshooting
LED Error
Battery reserve has been
reached
«Alternating» Error when
charging the battery
«Permanent» An error has
occurred
«Flashing» A serious error
has occurred
Speed sensor error
Internal system error
identified
Brake lighting error
Tab. 07:Fault Information
If you experience any problems using your
Brose Drive System, first check the items
listed in the following table. In many cases,
you can already remedy this yourself.
Solution
Charge battery
Too high or too low temperatures cause an error.
Disconnect the battery and charger from the
power source, wait until the temperature of the
battery and charger has returned to normal. The
temperature must be between 0° and 45°.
Connect the battery and charger with the power
source once again.
Check the following points for possible
assistance.
Check speed sensor and position of the spoke
magnet
Restart the system
If the problem persists, please contact an
authorised e-bike dealer.
Switch off the system completely. Then check
all cables and plugs on the front and/or rear
lighting. Restart the system.
ENG |
29