brose Display Remote Benutzerhandbuch Seite 26

26 | ENG
Switching off
To switch off the e-bike system you have the
following options:
› Press the «On/Off» key on the control unit
for at least 1.5 seconds.
› Switch off by pressing the «On/Off» key on
the e-bike battery (bicycle manufacturer-
specific solutions are possible that do
not have access to the battery «On/Off»
key, see battery/bicycle manufacturer's
manual).
» The system takes about 3 seconds to
completely switch off. You will not be
able to turn the system on again until it
has completely shut down.
Control and display unit, drive unit and battery
are completely switched off.
If the e-bike drive power is not called up for
approx. 15 minutes (e.g. because the e-bike is
stationary) and no key is pressed on the e-bike
control unit, the e-bike system and thus the
battery will switch off automatically for energy
saving reasons.
The control/ display unit is always switched
on; even if motor assistance is deactivated
(«OFF»).
Always turn off the Brose Drive System when
you stop the e-bike.
Assistance level
You can use the control unit to adjust how
much the e-bike drive assists you when
pedalling. The assistance level can be changed
at any time, even while riding.
Your Brose Drive System has four assistance
levels. The characteristics of the respective
Operation and Control | Remote
assistance mode can be found in the following
table:
Assistance levels
OFF
No motor assistance. At the
same time resistance-free
cycling
ECO
Noticeable motor assistance for
maximum efficiency and range
TOUR
Very noticeable motor
assistance, ideal for lengthy
tours
SPORT
Powerful assistance for sport
cycling
BOOST
Full assistance for sport cycling,
on hilly routes and in city traffic
with normal battery range
WALK ASSIST
Tab. 04: Assistance Level
To increase the level of assistance, press the
«Increase key» (Fig. B-d) on the control panel
until the desired level of assistance appears on
the LED bar; to decrease, press the «Decrease
key» (Fig. B-e).
For 5 seconds you will see the selected
assistance level.
If you press the «Increase» or «Decrease»
button, the status LED changes colour to blue
and your current assistance level is displayed.
The number of illuminated LEDs on the LED
strip indicate the selected assistance level
(see table).