Using The Product For The First Time; Inserting / Replacing Batteries - Miomare HG00718 Bedienungs- Und Sicherheitshinweise

which could affect batteries /
rechargeable batteries, e.g. ra-
diators / direct sunlight.
Avoid contact with the skin, eyes
and mucous membranes. In the
event of contact with battery acid,
thoroughly flush the affected area
with plenty of clean water and
seek immediate medical attention.
WEAR PROTECTIVE
GLOVES! Leaked or
damaged batteries / rechargea-
ble batteries can cause burns on
contact with the skin. Wear suit-
able protective gloves at all times
if such an event occurs.
In the event of a leakage of bat-
teries / rechargeable batteries,
immediately remove them from
the product to prevent damage.
Only use the same type of bat-
teries / rechargeable batteries. Do
not mix used and new batteries /
rechargeable batteries.
Remove the batteries / recharge-
able batteries if the product will
not be used for a longer period.
Risk of damage of the product
Only use the specified type of
battery / rechargeable battery!
Insert batteries / rechargeable
batteries according to polarity
marks (+) and (-) on the battery /
8 GB/CY
rechargeable battery and the
product.
Clean the contacts on the battery /
rechargeable battery and in the
battery compartment before in-
serting!
Remove exhausted batteries /
rechargeable batteries from the
product immediately.
Using the product for
the first time
Note: Please remove all packaging material from
the product.
Note: The product has two viewing sides. One side
is the regular plane mirror on the main body
the other side has a 5 x magnification mirror.

Inserting / replacing batteries

Rotate the mirror side with 5 x magnification
counter clockwise and remove the cover
(see Fig. A).
Remove the battery cover
housing and insert the batteries. Please note
the correct polarity, which is displayed in the
battery compartment
Close the battery cover
cover after inserting / changing the batteries
2
by turning it clockwise (see Fig. A).
Note: When reapplying the cover
sure the cover is positioned with the protruded
2
dot mark of the cover inserting to the groove on
the main body before rotating the cover
1
(see Fig. B).
and
1
2
inside the mirror
6
(see Fig. C).
7
and replace the
6
, make
2
2