Installation; Installing The Tap; Operation - Miomare HG02615 Montage-, Bedienungs- Und Sicherheitshinweise

CAUTION! DANGER OF SCALDING!
When making the hot water setting please ensure
that the temperature of the water is not too high.
Before installation, make yourself familiar with
all the existing services, e.g. water connection
and stopcocks.
Please read carefully through these operating
instructions before installing and using the product.
Keep all the safety advice and instructions in a
safe place for future reference!

Installation

Installing the tap

Note: To protect the parts from scratches while
being screwed together cover them with a damp
cloth or use plastic clamps.
Before you start installation turn off the main
water supply to prevent serious leakage of water.
Install the tap at the wall connection as shown
in Figure A.
Connecting the accessories (shower head
and shower hose)*:
Note: So that the parts do not get scratched while
being screwed together, protect them with a damp
cloth or use plastic clamps.
Screw an ordinary shower hose* firmly on to
the thread .
4b
Attach an ordinary shower head* to the shower
hose*.
Observe the installation instructions for the
accessories.
* (not included)
Flushing the tap
The tap must be flushed through before first use
to remove any dirt. To do this, follow these steps
(see Fig. B):
10 GB/IE
Screw the mixer nozzle
Before using the tap for the first time, open the
main water supply. and allow the water to run for
two minutes so that any residues are dissolved
away.
Then screw the mixer nozzle on again.

Operation

Bringing into use
Note: If the tap has not been used for a long period
flush the pipes through thoroughly in order to avoid
stagnation and build-up of residues in the drinking
water supply.
Open the main water supply.
Lift the control lever
or left to regulate the strength or temperature
of the water flow.
Hot water:
Swivel the control lever to the left.
Cold water:
Swivel the control lever to the right.
Check that the mixer tap is working properly.
To do this, swivel the lever into all the possible
positions. Please check the connections regularly
for leaks.
Changeover knob water
inlet bath / shower head
Filling the bath:
Press down the changeover button
water flows through the mixer nozzle
Showering:
Lift up the changeover button. The water flows
through the shower hose and the connected
shower head.
off.
4c
and swivel it to the right
6
. The
4a
.
4c