Pressure Stable - WIKA CPB 3000 Betriebsanleitung

Pressure Balance
CPB 3000
If the connected instrument has still not been filled enough or if the required pressure
has still not been reached, repeat steps 1) to 6) until the test specimen indicates the
appropriate pressure.
(5)

3.2.3 Pressure stable

Continue admitting pressure until the system is in a state of equilibrium.
In this case the lower edge of the bell must stay at the position of the marking line of the
piston/cylinder system.
Lower edge of the
bell
WIKA Operating Instructions Pressure Balance Version 1.1
(4)
(3)
(2)
(1)
(1) Star handle
(2) Shut-off valve for test connection
(3) Shut-off valve for reservoir
(4) Test specimen
(5) Piston/cylinder system
Marking line for float
position
GB
.
17