How To Fill And Empty The Tank; Water Level - Sunny Health & Fitness OBSIDIAN SURGE 500 METER SF-RW5713 Bedienungsanleitung

Inhaltsverzeichnis

Verfügbare Sprachen

HOW TO FILL AND EMPTY THE TANK

1. Remove the Fill Plug (No. 33) from the Upper Tank Cover (No. 12).

2. To fill the tank with water, refer to Fig. A. Insert the Funnel (No. 77) into the tank, then use a

cup or the Pumping Siphon (No. 76) and a bucket to fill the tank. Use the water level gauge

on the side of the tank to measure desired water level in the tank.

3. To empty the tank, refer to Fig. B. Place a bucket next to the rower, and use the Pumping

Siphon (No. 76) to pump out the water from the tank into the bucket.

4. Insert the Fill Plug (No. 33) into the Upper Tank Cover (No. 12). Wipe excess water off the

frame.

NOTE:

• Fill the tank only with tap water. Add 1 water purification tablet (1 packet is included.). Never

use pool chlorine or chlorine bleach. This will damage the tank and void the warranty.

• Add a water purification tablet every 6 months or as needed. If water remains cloudy, replace

the water in the tank.

• Do not consume the tank water. Dispose of the water after pumping it out from the tank.

• See Fig. A. The water level gauge is on the side of the tank. The maximum fill level is 6.

Never fill over this limit. Filling the tank over this limit will void the warranty.

• The resistance depends on the water level in the tank. Water level 1 is the lowest resistance.

Level 6 is the highest resistance.

Inhaltsverzeichnis