Sunny Health & Fitness OBSIDIAN SURGE 500 METER SF-RW5713 Bedienungsanleitung Seite 10

We value your experience using Sunny Health and Fitness products. For assistance with parts or
troubleshooting, please contact us at support@sunnyhealthfitness.com or 1-877-90SUNNY (877-
907-8669).
STEP 4:
NOTE: Move the Seat (No. 36) to the front of
the Slide Rail (No. 3) before assembly to
prevent it from gliding down during assembly.
Attach the Slide Rail (No. 3) to the Main Frame
(No. 1) using 4 Washers (No. 71), 4 Screws
(No. 60), and 4 Flat Screws (No. 58). Insert all
8 screws partially into the holes first, and then
tighten with Allen Wrench (No. 74).
STEP 5:
Connect the link wires of Inductor (No. 47) with
2 Sensor Wires (No. 93).
Attach Sensor Stand (No. 5) to Main Frame
(No. 1) using 4 Washers (No. 71) and 4 Screws
(No. 60). Tighten with Allen Wrench (No. 74).
If you are sitting on the seat, the arrow sticker
on the Sensor Stand (No. 5) must be pointing
towards you. That means the Sensor Stand
(No. 5) is installed in the correct direction.
STEP 6:
Connect 2 Sensor Wires (No. 93) with the link
wires of Meter (No. 46).
Attach Meter (No. 46) to Sensor Stand (No. 5)
using 1 Bolt (No. 63), 2 Washers (No. 71), and
1 Nylon Lock Nut (No. 56). Tighten with Allen
Wrench (No. 74) and Spanner (No. 75).
Make sure it is not too tight to adjust the angle
of Meter (No. 46).
The assembly is complete!
9