Batavus C4 Betriebsanleitung Seite 4

Push the tube cover together with the housing
foam ring downward onto the housing.
HANDLEBAR
Assemble the handlebar tube together with the
handlebar clamp, the screw, the washer, the
spacer sleeve and the hand wheel for adjusting
the handlebars. To do this, place the handlebar
tube into the mount (E) on the handlebar shaft.
The pin (F) for the handlebar tube must
CAUTION:
be inserted into the groove (G). Then push the
handlebar clamp over the handlebar tube and first
loosely insert the lower screw with the washer. The
handlebar clamp should uniformly wrap around
the handlebar tube.
cable! Insert the spacer sleeve into the upper hole
and tighten. Next, push the cable for the hand
pulse sensors through the opening (H) beneath the
mounting plate and thread it upward out of the
handlebar shaft.
CONSOLE
4
Do not pinch the
CAUTION:
To assemble the console, you must first connect the
top cable and the cable for the hand pulse sensors
to the console cables. Then push the console
downward onto the mounting plate (i) on the
handlebar shaft. Do not pinch the cable!
CAUTION:
Then, fasten the console using the screws. Do
not tighten the screws too much. If you wish, you
may insert the book holder into the slot (J) on the
console. Push the console cap upward beneath the
console until it latches into place. Make sure that
the latching pins (K) seat properly.
SEAT
Insert the seat support. Insert the hand wheel for
adjusting the seat and latch the pin of the hand
wheel into a hole in the seat support. Then tighten
the hand wheel. To attach the seat to the seat
support, push the previously assembled clamp (L,
beneath the seat) onto the mounting tube (M) on
the seat holder. Align the seat and screw it tight in
the desired position using the clamping screw. You
can now set the horizontal distance between the
handlebars and the seat using the hand wheel for
setting the seat depth.