Description Of The Inogen One® G5 Oxygen Concentrator; User Controls; User Interfaces - Inogen One G5 Handbuch

3. Inogen One® G5 Oxygen Concentrator Description
5

User Controls

Item Description
1 ON / OFF Button
2 Flow Setting
Control Buttons
3 Volume Control
Button
4 Audible Alert
Button

User Interfaces

Item Description
5 Display
6 Indicator Lights
7 Audible Signals
8 Backlight
5
8
7
Function
Press once to turn "ON"; Press and hold for one second to turn "OFF".
Use the – or + flow setting control buttons to select the setting as shown
on the display. There are six settings, from 1 to 6.
Pressing this button will change the volume level, from 1 to 4.
Pressing this button will toggle the Inogen One® G5's breath detection
audible alert on and off.
Breath Detection Alert Mode. The Inogen One® G5 will alert with audible
and visual signals for "no breath detected" when this mode is enabled
and no breath has been detected for 60 seconds.
At 60 seconds, the device will enter into auto pulse mode and once
another breath is detected, the device will exit auto pulse mode and
deliver normally on inspiration. The display's mode indication area will
show a bell icon, flashing yellow light and display message when the alert
is enabled.
If power is lost, the breath detection audible alert remains set in the user
preferred mode.
Function
This screen displays information regarding flow setting, power status,
battery life and errors. Display appearance will vary. Before use, remove
the static cling FCC label from the screen.
A green light indicates breath detection. A yellow light indicates either a
change in operating status or a condition that may need response (alert).
A flashing light is higher priority than non-flashing.
An audible signal (beep) indicates either a change in operating status or
a condition that may need response (alert). More frequent beeps indicate
higher priority conditions. The default volume is set at level 1 and can be
adjusted to higher settings but it can not be silenced. If power is lost, the
audible signal remains set in the user preferred adjusted setting.
A backlight will illuminate the screen for 15 seconds when the on/off
button is briefly pressed.
2
4
1
3
6