Final Assembly; Mounting F.m; Mounting - Honeywell 010120.17 Montage, Anschluss, Anleitung

22
10.

Final assembly

10.1

Mounting f.m.

For use in compliance with VdS, use the enclosed cover frame!
For use not in compliance with VdS, use a standard cover for flush mounted boxes instead of
the enclosed cover frame (s.b.).
Mount cover frame
The cover frame has 4 light pipes for the LED indicator that is visible from outside. For LEDs, that
should remain invisible, press the light pipe out of the cover frame from the inside.
- Fix the cover frame to the module with the 4 enclosed screws.
- Check that the module is functioning correctly.
Proceed as follows when the system is functioning correctly.
- Remove the protective foil from the decorating foil.
- Glue the foil to the cover frame. The module can now no longer be opened without destroying
the decorating foil
Standard cover
A standard cover can be painted or covered with wallpaper as required.
ATTENTION!
As the cover contact of standard covers is not activated!
Adapt the lever of the cover contact (bend)
or
Bridge the cover contact (see illustration)
10.2 Mounting s.m.
The housing cover has 4 light pipes for the LED indicator that is visible from outside.
Mounting in compliance with VdS:
Strain relief of cables:
Before closing the housing, secure the cable binders at the provided retainers .
Seal housing:
Seal the housing after mounting correctly and testing the system by pressing the plastic seals into the
screw openings on the front of the housing.
Clean the seals(free from grease) and cover with the labels (VdS imprint).
After attaching the plastic seals, the housing cannot be opened without destroying the seals.
Mounting and Connection Instructions DUO I/O-Module BUS-2/BUS-1
Bridge
solder pads
Cover contact