Final Assembly - Honeywell 010121.17 Montage, Anschluss, Anleitung

14 Mounting and Connection Instructions
5.

Final assembly

For use in compliance with VdS, use the enclosed cover frame!
For use not in compliance with VdS,
instead of the enclosed cover frame (s. b.).
Mount cover frame
The cover frame has 4 light pipes for the LED indicator that is visible from the outside. If the
LEDs, should remain invisible, press the light pipe out of the cover frame from the inside.
- Fix the cover frame to the module with the 4 enclosed screws.
- Check that the module is functioning correctly.
Proceed as follows when the system is functioning correctly.
- Remove the protective foil from the decorating foil.
- Glue the foil to the cover frame. The module can now no longer be opened without destroying
the decorative foil.
Standard cover
A standard cover can be painted or covered with wallpaper as required.
ATTENTION!
As the cover contact
Adapt the lever of the cover contact (bend)
or
Do not connect cover contact
or
Bridge the cover contact (see illustration).
a standard cover for flush mounted boxes can be used
of standard covers is not activated!
DUO Switching Module 230V AC / 8A
Bridge
solder
pads
Cover contact
, f.m.