SATA AE1016H Gebrauchsanweisungen Seite 81

8.3 Gap Adjustment between the Dismounting Head and Rim
8.3.1
8.3.2 Adjust the square locking plate for the front and rear gaps;
Close the air source and adjust two square locking plate jackscrews at the rear of upper seat of column with 6# internal hexagon wrench
(Fig. 8-3B). If the gap is too large, fit the jackscrew and lock it with 18# external hexagon wrench; if the gap is too small, adjust it reversely.
AE1016H/AE1016H-3
中文
EN DE
Adjust the locking plate of hexagonal shaft for the upper
and lower gaps; close the air source and remove the
protective cover of vertical hexagonal shaft. If the gap is
too large, adjust the front nut of locking plate of hexagonal
shaft downwards with 16# exterior hexagon wrench (Fig.
8-3A); if the clearance is too small, adjust it upwards.
Fig. 8-3
RU KO PT JA ES
81