SATA AE1016H Gebrauchsanweisungen Seite 65

6.2 Inflate the tire with the optional IT system
The optional (IT system) is suitable for the inflation of vacuum tire.
During this process, the noise may reach 85 db. It is preferably to wear the noise protection device.
- Fix the wheel on the large plate and connect the inflation head with the air valve.
- Finally check the dimensional fit between the tire and rim.
- Check if the tire edge is fully lubricated and perform the further lubrication if necessary.
- Press the pedal to the middle position.
- Check the air pressure while inflating the tire Until the pressure reaches the required value
Explosion risk!
Tire inflating pressure shall not be more than 3.5 bar (51 psi): if the higher pressure is required, remove the
tire from the large plate and inflate it in the special protective cage. Do not exceed the inflating pressure
recommended by manufacturer, and keep the hand and body behind the tire being inflated: the inflation shall be
conducted only by the specially trained and authorized personnel, and others shall not operate or stay near the
tire changer.
AE1016H/AE1016H-3
中文
EN DE RU KO PT JA ES
65