Switching On And Off; Sharpening The Saw Chain - FLORABEST FSG 85 C2 Originalbetriebsanleitung

GB MT
Keep hands away from the grind-
ing disk and chain teeth when the
equipment is in use. Do not move
the chain by hand. There is a risk of
injury.

Switching on and off

Ensure that the mains voltage
matches the specifications on the
rating plate.
Connect the equipment to the
mains.
1. To switch on, press the "I" On switch
(green) and the device starts up (see
1a).
2. To switch off, press the "0" Off switch
(red) and the device switches off (see
1b).
The disk will continue to
run after the equipment is
switched off. There is a risk
of injury.
Protection against overheating and
restart:
The unit will not automatically restart fol-
lowing an automatic cutout due to over-
load.
To restart the grinder, press the "I" On
switch (green) and the device starts up (see
1a).
Test run:
Before starting work and after each
change of grinding disk, carry out a test
run of at least 30 seconds with no load.
Switch off the equipment immediately if the
disk runs lumpy, substantial vibrations oc-
cur, or abnormal noises are generated.
56

Sharpening the saw chain

When working with the saw chain,
keep clean the ventilation openings
(see "Maintenance and cleaning").
In case of a blockage, switch off
the equipment and disconnect from
the mains. Only then should the
blockage be removed.
An incorrectly sharpened
saw chain may damage the
chain the increase the risk of
the saw jumping back.
Ensure that the chain is
aligned accurately.
Observe the correct rake an-
gle and minimum dimensions
of the saw chain. Remove as
little material as possible.
Do not grind in
drive (a) or con-
necting (b) links,
otherwise the saw
chain may rupture.
In the event of non-obser-
vance, there is a risk of acci-
dents when handling the
chainsaw.
Instructions for sharpening
• Clean the saw chain before you sharp-
en it. Use a brush or cloth to remove
oily wood chips or residual oil.
• After sharpening, all cutting links must
be of equal length and width.
• The chain is worn and must be re-
placed with a new saw chain if only
approx. 4 mm of cutting tooth remain.