Installation; Operation; Working With The Equipment - FLORABEST FSG 85 C2 Originalbetriebsanleitung

Installation

Always use the M10x70 screws
from the package to mount the unit.
Make sure to leave enough
room for working and that
nobody else is put at risk.
Always use screws of suf-
ficient length and thickness
to mount the device on the
work surface, in order to
prevent loss of control of the
device.
Installing the appliance:
- Thickness of the table edge:
15 - 30 mm.
- Drill diameter: 10.5 mm.
- Size of screw: M10
1. Use the stop notches (9) to cor-
rectly place the appliance on the
worktop (22). Make sure that the
grinding plinth (8) protrudes be-
yond the edge of the table.
2. Use a pen to mark the drill holes
and remove the appliance.
3. Drill two holes into the worktop
(22).
4. Using the enclosed screws (23),
washers (24a) and nuts (24b),
screw the grinding plinth in place
on the worktop.
Assembling the grinder:
5. Screw the handle (4) into the
grinding head (2).
6. Remove the locking screw (10)
from the chain clamping unit (12).
7. Place the chain clamping unit
(12) on the grinding plinth (8)
and fix it using the locking screw
(10).
8. Snap the mains lead (17) into the
cable hook (16).
Screwing on the adjusting
screw:
9. Place the enclosed washer (25)
on the adjusting screw (6).
10. Screw the adjusting screw (6)
onto the securing nut (26) fixed
into the grinding head (2).

Operation

Working with the equipment

Caution! Risk of injury!
- Use only grinding disks and acces-
sories recommended by the manu-
facturer. The use of other insertion
tools and other accessories may
cause risk of injury.
- Never operate the device without
the visual protection disk.
- Do not use saw blades.
- Check the grinding disk before
use: check the distance between
the protective screen and the
grinding disk.
- Do not use broken, cracked or oth-
erwise damaged grinding disks.
- Switch on the equipment only
when it is safely installed on the
work surface.
Risk of injury!
Wear ear, eye and hand protection!
When working with the saw chain,
wear cut resistant gloves and an
apron if necessary, to avoid inci-
sion injuries.
GB MT
55