Troubleshooting; Technical Specification - Hendi 222829 Bedienungsanleitung

Storage
• Before storage, always make sure the appliance
has already been disconnected from the electri-
cal outlet and cooled down completely.

Troubleshooting

If the machine does not function properly, please check the below table for the solution. If you are still una-
ble to solve the problem, please contact the supplier/service provider. DO NOT repair yourself.
Problems
Machine do not start running
Machine stops during operation
Machine sound too noisy
EN
Attachments cannot install onto the
planetary shaft easily
Lift up / Lower bowl lever (12) not op-
eration easily

Technical specification

Item no.: 222829
Operating voltage and frequency: 220- 240V~ 50/60Hz
Rated input power: 650W
Protection class: class I
Waterproof protection class: IP23
Maximum capacity: 7 litres (800g of flour + 500g of
water)
Remark: Technical specification is subjected to change without prior notification
10
• Store the appliance in a cool, clean and dry place.
Possible causes
Bowl guard (6) is not in properly
closed position.
Bowl (2) is not raised to the proper
location.
The power plug is not connected
properly.
Internal overload activates to prevent
overheat.
Damage or broken transmission belt
Machine is not placed on a horizontal
surface.
Bowl (2) is not placed correctly.
Attachments not fitted properly.
Bowl is overloaded.
Damaged or worn transmission belt.
Planetary gear needs lack of lubri-
cant.
Lack of lubricant and / or cleaning of
the planetary shaft required.
Lack of lubricant on the bowl slides.
Rotation speed (rpm): Flat beater (250); Dough
hook (128); Whisk (540)
Dimension: 240x420x(H)425mm
Net weight: approx. 21kg
Noise level: approx. 70 dB (A)
Possible solution
Rotate the bowl guard (6) to the right
until fully closed properly.
Raise the bowl (2) to the correct posi-
tion by using the level (12).
Check to make sure the power plug is
connected properly.
Press OFF the button (11) and then
press RESET button (14) at the back.
Check with the supplier
Adjust the surface or move to another
horizontal surface.
Make sure the bowl (2) is placed into
the bowl cradle (15) correctly with the
guided pins (3).
Remove and install the attachments
into position again.
Reduce ingredients capacity.
Check with the supplier.
Wipe planetary shaft with a clean
damp cloth and lubricate the shaft
with mineral oil or grease.
Lubricate bowl slides with mineral oil
or grease.