Operation - Hendi 222829 Bedienungsanleitung

Operation

To avoid serious personal injury:
• DO NOT operate the machine without reading the
instruction manual.
• ALWAYS switch OFF the machine and unplug
from electrical power supply before cleaning,
maintenance, repair or changing any attach-
ments.
a) About the bowl guard
Note: When bowl guard (6) is open or not properly closed in lock position, the machine will not operate.
1. To open the bowl guard (6), hold the bowl guard
handle (5) and rotate it clockwise. To close the
bowl guard (6), hold the bowl guard handle (5)
and rotate it anti-clockwise.
b) Install the bowl (2) to the machine
Note: Install the bowl (2) BEFORE fixing the attach-
ments. Use the supplied bowl (2) only.
1. Lower the bowl by pulling the bowl lift-up lever
(12) downwards until it stops. So that the bowl
cradle (15) is in a lower position.
c) Install different attachments (Flat beater, Dough hook or Whisk) to the machine
Note: It is more convenient and easier to install the
attachments prior to adding the ingredients
into the bowl (2).
1. Rotate the bowl guard (6) clockwise gently, so
that it is in the open position.
2. CAUTION! Use excessive force to open or close
the bowl guard (6) may damage the safety lock
micro switch. Be careful when open or close the
bowl guard (6).
d) Pouring and mixing ingredients
Note: Follow the table of Mixing ingredients capac-
ity in this manual. Overloading will lead to
overflow or damage to the machine.
IMPORTANT: Make sure the speed control lever (7)
is set at the position 1.
1. Add all the appropriate ingredients into the bowl
(2).
• ALWAYS keep hands, hair and loose clothing
away from the moving parts.
2. When the bowl guard handle (5) is lined up at
the right side of the machine, the bowl guard (6)
is in the is in the rocked position and ready for
operation.
2. Place the bowl (2) carefully and slowly using the
bowl handles (4) at 2 sides and
i) With the locking pin into the hole at
the middle of the bowl cradle (15) and
ii) Align with guided pins on 2 sides of
the bowl cradle (15).
3. Slide the attachments (Flat beater, Dough hook
or Whisk) slowly upwards onto the planetary
shaft fitting the shaft pin through the slot in the
attachments.
4. Rotate the attachments to secure it onto the
planetary shaft.
2. Lift upwards the bowl lift lever (12) until the bowl
(2) locks into the position.
3. Rotate the bowl guard (6) anti-clockwise and
locks into the position.
Attention: The machine will not start if the bowl
guard (6) is open / not closed properly or the bowl
(2) is at the lower position.
EN
7