Troubleshooting - Hendi 222157 Gebrauchsanweisung

Cleaning and Maintenance
Attention: Always unplug the appliance from the electrical power outlet and let it cool down com-
pletely before cleaning and disassembly the blending part (7).
Cleaning
• Remove all obstacles near the blade.
• Place the blending arm and the bell in a suit-
able container with clean water and switch
on for a few seconds. Never immerse the
shaft above the Max. mark.
Recommended cleaning procedure:
Parts
Main unit with motor
(10)
Blending part (7)
Blade (8)
EN
Storage
• Before storage, always make sure the appli-
ance has already been disconnected from the
electrical outlet and cooled down completely.

Troubleshooting

If the appliance does not function properly,
please check the below table for the solution.
Problems
Appliance does not switch on
Abnormal noises while pro-
cessing
Appliance cannot operate
Appliance is overheat
8
How to clean
• Never immerse this part into water or other liquids.
• Using a damp cloth with some detergent and water, rinse,
sanitize and dry thoroughly.
• Clean it with warm water and some mild detergent. Do not
submerge the Detachable blending part (7) above the Max.
mark.
• Dry all parts before using again.
• Warning! Risk of injury! Take great care when cleaning the
blades.
• Clean it with warm water and some mild detergent.
• Dry it thoroughly after cleaning.
Possible causes
Power plug is not connected to a
suitable power supply properly.
ON/OFF button (1) is not pressed.
The blending part (7) is not con-
nected correctly.
Inside overheat devices activates.
Overtime operation
• Never immerse the motor unit or the han-
dle in water; clean with a damp cloth or a
sponge.
WARNING: Always dry the blades thoroughly
after cleaning to avoid rust spotting.
• Store the appliance in a cool, clean and dry
place and keep out of reach of the children.
If you are still unable to solve the problem,
please contact the supplier/service provider.
Possible solution
Check to make sure the power plug is
connected to a suitable electrical outlet
properly.
Press and hold the ON/OFF button (1) to
switch on the appliance.
Disassembly and assembly the blending
part (7) again.
Let the appliance cool down complete
before start operation again.
Release the ON/OFF button and unplug
the device, wait 10 minutes for the mo-
tor to cool down.
Frequency
Clean after each
use