Troubleshooting - Hendi 222157 Gebrauchsanweisung

Cleaning and Maintenance
Attention: Always unplug the appliance from the electrical power outlet and let it cool down completely before
cleaning and disassembly the blending part (7).
Cleaning
• Remove all obstacles near the blade.
• Place the blending arm and the bell in a suitable
container with clean water and switch on for a
few seconds. Never immerse the shaft above the
Max. mark.
Recommended cleaning procedure:
Parts
Main unit with motor
(10)
Blending part (7)
Blade (8)
Storage
EN
• Before storage, always make sure the appliance
has already been disconnected from the electrical
outlet and cooled down completely.

Troubleshooting

If the appliance does not function properly, please
check the below table for the solution. If you are
Problems
Appliance does not switch on
Abnormal noises while pro-
cessing
Appliance cannot operate
Appliance is overheat
8
How to clean
• Never immerse this part into water or other liquids.
• Using a damp cloth with some detergent and water, rinse, sanitize and
dry thoroughly.
• Clean it with warm water and some mild detergent. Do not submerge
the Detachable blending part (7) above the Max. mark.
• Dry all parts before using again.
• Warning! Risk of injury! Take great care when cleaning the blades.
• Clean it with warm water and some mild detergent.
• Dry it thoroughly after cleaning.
Possible causes
Power plug is not connected to a
suitable power supply properly.
ON/OFF button (1) is not pressed.
The blending part (7) is not con-
nected correctly.
Inside overheat devices activates.
Overtime operation
• Never immerse the motor unit or the handle in
water; clean with a damp cloth or a sponge.
WARNING: Always dry the blades thoroughly after
cleaning to avoid rust spotting.
• Store the appliance in a cool, clean and dry place
and keep out of reach of the children.
still unable to solve the problem, please contact the
supplier/service provider.
Possible solution
Check to make sure the power plug is connected
to a suitable electrical outlet properly.
Press and hold the ON/OFF button (1) to switch on
the appliance.
Disassembly and assembly the blending part (7)
again.
Let the appliance cool down complete before start
operation again.
Release the ON/OFF button and unplug the device,
wait 10 minutes for the motor to cool down.
Frequency
Clean after each
use