Switching On And Off; Selecting The Correct Rotational Speed And Sanding Belt - Parkside pebS 900 Se Bedienungs- Und Sicherheitshinweise

Emptying the dust collection box:
j
Pull the dust collection box
extraction spout
5
box and empty it.
10
Dust extraction using external vacuum
extraction:
WarNING! If there is an explosive mixture
of dust and air you must use a vacuum device espe-
cially intended for that purpose.
DaNGEr OF FIrE! Do not use vacuum dust
extraction (dust collection box or vacuum cleaner)
when sanding metals (flying sparks).
1. Push the extraction adapter
extraction spout
5
(see Fig. C).
2. Slide the hose of a suitable dust extraction de-
vice approved for that purpose (e.g. a workshop
vacuum cleaner) on to the extraction adapter
Operation
Q

Switching on and off

Q
The PEBS 900 SE belt sander has full-wave electro-
nics with additional control electronics, soft start
with inrush current limiting.
When operating the belt sander you can select
between intermittent or continuous operation mode.
For short sanding tasks use the intermittent operation
mode. For longer sanding tasks we recommend the
continuous operation mode. Whilst working in your
selected mode the device functions as follows:
To switch on intermittent operation mode:
j
Press the ON / OFF switch
To switch off intermittent operation mode:
j
Release the ON / OFF switch
off the dust
10
. Open the dust collection
on to the dust
11
on the side of the device
3
.
3
.
Preparing for use / Operation
To switch on continuous operation mode:
j
Press the ON / OFF switch
pressed, then press the locking knob
To switch off continuous operation mode:
j
Press and then release the ON / OFF switch
Selecting the correct rotational
Q
speed and sanding belt
You can select the belt speed using the belt speed
adjuster wheel
1
The optimum belt speed depends on the workpiece
and the workpiece material. Always confirm the
best speed by carrying out a small test. The follow-
ing table lists some recommended values to help
you determine the optimum speed.
.
11
Material / type of
work
Coarse finish
(Grit grade)
Fine finish (Grit grade) 240
Preselected rotation
speed
Material / type of
work
Coarse finish
(Grit grade)
Fine finish (Grit grade) 180
Preselected rotation
speed
Material / type of
work
Coarse finish
(Grit grade)
Fine finish (Grit grade) 150
Preselected rotation
speed
, and keep it
3
even whilst the sander is running.
Softwood
60
high (5-6)
Hardwood
60
high (5-6)
Chipboard
60
high (5-6)
2
.
3
.
GB 11