Maintenance - Dimplex CAMBRIDGE STANDARD Installationsanleitung

Lamp Replacement
- see Fig.'s 3, 4 & 5
To gain access to the lamps, open the hinged ash-pan flap (see Fig. 3
& 4). Carefully tilt the tray upwards (see 'a' in Fig. 5) and then slide out
the lamp-holder tray (see 'b' in Fig. 5).
Unscrew the defective lamp anti-clockwise until it comes out of its
holder.
Replace the defective lamp with a 230V, 60W max, E14 SES candle
lamp, rotating the lamp clockwise in the holder until it is fully home. Do
not over tighten.
Note: Actual models shown in Fig. 4 & 5 are Deluxe models.
Thermal Safety Cut-out
For your safety, this appliance has been fitted with a thermal cut-out. In
the event that the product overheats, the cut-out switches the heat off
automatically.
To bring the heat back into operation, remove the cause of the
overheating, then unplug or turn off the electrical supply to the heater
for up to 10 minutes.
When the heater has cooled sufficiently, re-connect and switch on the
heater.

Maintenance

WARNING: ALWAYS DISCONNECT FROM THE POWER SUPPLY
BEFORE ATTEMPTING ANY MAINTENANCE.
Cleaning
WARNING – ALWAYS DISCONNECT FROM THE POWER SUPPLY
BEFORE CLEANING THE HEATER.
For general cleaning use a soft clean duster – never use abrasive
cleaners. The glass viewing screen should be cleaned carefully with
a soft cloth. DO NOT use proprietary glass cleaners.
To remove any accumulation of dust or fluff the soft brush attachment
of a vacuum cleaner should occasionally be used to clean the outlet
grille of the fan heater.
Recycling
For electrical products sold within the European Community.
At the end of the electrical products useful life it should not
be disposed of with household waste. Please recycle where
facilities exist. Check with your Local Authority or retailer for
recycling advice in your country.
After Sales Service
Should you require after sales service or should you need to purchase
any spares, please contact the retailer from whom the appliance was
purchased or contact the service number relevant to your country on
the warranty card.
Please do not return a faulty product to us in the first instance as this
may result in loss or damage and delay in providing you with a
satisfactory service.
Please retain your receipt as proof of purchase.
- 2 -
UK