Resetting The Hands-Free Kit; Charging 5 V Devices - Silvercrest IAN 279754 Bedienungsanleitung

Resetting the hands-free kit

The hands-free kit can be paired with up to 8 mobile
phones. To delete the pairing list and reset the hands-free
kit to the factory defaults, proceed as follows:
Ensure that the hands-free kit is in standby mode.
Press and hold the multifunction button
10 seconds until you hear two beeps and the LED
status indicator
is deleted and the hands-free kit is reset to the factory
defaults.
Note:
After resetting to the factory default settings, the hands-
free kit will automatically be in pairing mode when it is
connected to a mobile phone.
If the hands-free kit is not connected to a mobile phone
after resetting to the factory defaults it will be in standby
mode.

Charging 5 V Devices

Check the max. input voltage (5V) and the max. power
input (1000 mA) of the device which you want to charge.
For this, consult the operating manual of the device.
Connect the device to be charged with the USB port
on the hands free device. The device now receives its
power supply from the hands free device. If the device
is equipped with a charging indicator light, this will in-
dicate that the device is being charged.
Note:
If the power supply does not activate automatically, you
should disconnect the USB cable from the USB port
and re-connect it.
│
■ 14
GB
flashes five times. The pairing list
for about
SBTF 10 C3