Troubleshooting; Fault Causes And Remedies - Silvercrest SDMF 1300 A1 Bedienungsanleitung Und Sicherheitshinweise

Troubleshooting

This section contains important information on fault identification and
rectification . Follow the instructions to avoid hazards and damage .

Fault causes and remedies

The following table will help you to identify and rectify minor malfunctions . If the
solutions presented below do not resolve the problem, please contact the Service
Hotline .
Fault
The appliance does
not emit steam .
The appliance emits
only a very small
amount of steam .
The appliance takes
a long time to heat
up and/or white
particles are coming
out of it .
Water drips from the
steam head
■ 68 │ GB │ MT
Cause
The appliance is not
switched on .
The water tank
empty .
The steam is used
up .
Limescale has
accumulated in the
appliance .
The water tank
empty .
There is no steam
available yet .
The steam is almost
used up .
Limescale has
accumulated in the
appliance .
Limescale has
. accumulated in the
5
appliance .
Remedy
Make sure that the appliance
is properly connected to the
power supply and press the
On/Off switch
LED should flash during
1
the heating phase .
Switch the appliance off and
is
0
fill the water tank
Allow the appliance to heat up
again .
See section "Cleaning" –
Descaling .
Switch the appliance off and
is
0
fill the water tank
The appliance does not start
producing steam until around
30 seconds after switching on .
Allow the appliance to heat up
again .
See section "Cleaning" –
Descaling .
See section "Cleaning" –
Descaling .
SDMF 1300 A1
. The blue
3
.
0
.
0