Storage; Troubleshooting - Silvercrest SFR 3.7 A2 Bedienungsanleitung

5) Then reassemble the appliance.
–
Push the grey rod back into the dirt container
and fix it in place with the nozzle
Make sure that the washers are correctly
placed.
–
Place the dirt container
unit .
–
Push the connecting piece
unit /the dirt container
into place.

Troubleshooting

Defect
The appliance is
not working.
Streaks keep
appearing during
cleaning.
The spray bottle
does not work.
If the malfunction cannot be corrected with the above suggestions, or if you have found
some other kind of malfunction, please contact our Customer Service.
■ 8 │
GB
.
onto the motor
onto the motor
, so that it clicks
Cause
The appliance is not charged.
The appliance is defective.
The blade is dirty.
The blade is worn.
Too much cleaning agent has been added.
There is no water/cleaning agent in the
spray bottle.
The spray bottle is defective.
The tip of the spray bottle is set to OFF.
–
Push the vacuum attachment
connecting piece
■ Wipe the charger
that the charger
reconnecting it to the mains.

Storage

■ Store the cleaned appliance in a clean, dust-free
and dry location.
Charge the appliance.
Contact Customer Services.
Clean the blade.
Remove the blade sideways from
the vacuum attachment
Moisten the blade at the round
end with water or detergent, turn
it over and push it back into the
vacuum attachment
Use less cleaning agent.
Refill the spray bottle with water/
cleaning agent.
Contact Customer Services.
Turn the tip to SPRAY or
STREAM.
onto the
.
with a damp cloth. Ensure
is completely dry before
Solution
.
.
SFR 3.7 A2