Inhaltsverzeichnis
Werbung
To check the seats:
1. Shut-off the hot water: check that there is no cross flow of cold water into the hot water
system.
2. Shut-off the cold water: check that there is no cross flow of hot water into the cold water system.
If there is cross flow, clean the seats or replace the thermostatic cartridge.
SERVICING AND CLEANING
• Cleaning chrome: Do not use abrasive, chlorine or acid-based cleaning products. Clean with soapy
water using a cloth or a sponge.
• Frost protection: Drain the pipes and operate the mixer several times to drain any remaining water.
REMEMBER:
• Our mixers must be installed by professional installers in accordance with current regulations
and recommendations in your country, and the recommendations of the fluid engineer.
• Sizing the pipes correctly will avoid problems of water hammer and loss of pressure/flow rate.
(See the calculation table in the brochure or on line at www.delabie.com).
• Protect the installation with filters, water hammer absorbers or pressure reducers to reduce
the frequency of maintenance.
• Install stopcocks close to the mixer to facilitate maintenance.
• The pipe work, stopcocks, check valves and all sanitary fittings should be checked at least once
a year, and more frequently if necessary.
For UK market only: Tel. 01491 821 821 email: technical@delabie.co.uk
For all other markets: Tel. +33 3 22 60 22 74 email: sav@delabie.fr
The most recent version of this installation guide is available on: www.delabie.com
After Sales Care and Technical Support:
EN
Werbung
Inhaltsverzeichnis
