Troubleshooting - Invacare Scorpius Gebrauchsanweisung

Scorpius
• If the storage environment is out of the range, we suggest you take out the battery box from the scooter
and store it respectively.
All maintenance and repair of scooter MUST be done by an authorized dealer. ANY unauthorized
adjustments, repair or service to the scooter may result injury to yourself or damage to scooter.

TROUBLESHOOTING

Here are some suggestions about solving problems you may have with your scooter. There is a self-
diagnostic warning light on the control panel. To check the self-diagnostic warning light, turn on the key
(power) switch (see section 4-2) and count the number of flashes on the warning light.
Figure 27
Self-Diagnostic Warning Light:
Flash Description
1 Battery low
2 Low battery fault
3 High battery fault
Current limit time-out or
4
controller overheat
5 Park brake
6 Drive inhibit
7 Speed pot
1654767~A
Touch screen version:
Normal: solid light
Abnormal: flashing light
Initial check points
The batteries are running low.
• Recharge the batteries.
The batteries have run out of charge.
• Recharge the batteries.
Check the battery and associated connections and wiring.
•
Battery voltage is too high. This may occur if overcharged and/or
travelling down a long slope.
• If travelling down a slope, reduce your speed to minimize the
amount of regenerative charging.
The motor has been exceeding its maximum current rating for too long.
• The scooter may have stalled. Turn the controller off, leave for a
few minutes and turn back on again.
• The motor may be faulty. Check the motor and associated
connections and wiring. See section 2-4.
Either a park brake release switch is active, or the park brake is faulty.
• Check the park brake and associated connections and wiring.
• Ensure any associated switches are in their correct positions.
Switch to D (drive) position. Turn off the power and turn on again.
•
Either a stop function is active, or charger inhibits or OONAPU condition
has occurred.
• Release the stop condition (seat raised etc.).
• Disconnect the battery charger.
• Ensure the throttle is in Neutral when turning the controller on.
• The throttle may require re-calibration.
• The folding/unfolding procedure is uncompleted.
The throttle, speed limit pot. SRW or their associated wiring may be
faulty.
• Check the throttle and speed pot and associated connections and
wiring.
Key switch v ersion:
Figure 28 Normal: solid light
Abnormal: flashing light
Instruction Booklet
22