Maintenance - Comet MTP MC 8 Anweisungen Für Den Zusammenbau, Die Bedienung Und Wartung

WARNING
• Always make sure that, once stop operations have been performed, no part of the motor pump and of the
machine in which it is integrated is moving and no pipes contain liquid under pressure.
Perform the stop operations contained in the manual of the machine in which the motor pump is integrated
and in that of any combustion engine equipping the machine; unless otherwise indicated, in relation to
the motor pump, remember the following.
a) Reset the delivery pressure as described at point c) of the
b) I n the case of motor pump equipped with electric motor, remove the plug of the machine in which it is
integrated from the power socket. In the case of motor pump equipped with combustion engine, disconnect
the spark plug contact.
c) W ait for the motor pump and the machine in which it is integrated to cool down.
WARNING
• Once the motor pump and the machine in which it is integrated have cooled down, be careful:
- not to leave them unattended in the presence of children, elderly people or disabled persons without supervision;
- to arrange them in a stable position without any risk of falling;
- not to put them in contact or in the immediate vicinity of inflammable materials.
WARNING
"p
• Read the
recautionS concerning pumped chemical productS
• All cleaning jobs must only be performed after carrying out the operations described in the
meaning without any moving parts, no pipe full of liquid under pressure and only after complete cooling.
In particular, always remember to disconnect the power supply or disconnect the spark plug contact.
• Any cleaning jobs must be performed in conditions of total stability.
• To clean, do not use thinners or solvents.
CAUTION
• Before proceeding to clean and decommission the motor pump, remember to run it for a few minutes with
clean water so as to clean the ducts and internal parts and remove the chemical products used.
• Do not leave the motor pump stopped with chemical products inside.
• The motor pump must be protected against freezing.
In very cold environments, to prevent the ice from forming inside, before decommissioning, it is best to
suction a car anti-freeze product and then proceed to fully expel it. If it is not possible to protect the motor
pump this way, before starting it, take it to a warm environment for long enough to melt any ice inside.
Failure to do so could cause serious damage to the motor pump.
WARNING
• The rinsing fluids and the antifreeze liquid must be suitably disposed of and not discarded in the environment.
WARNING
• Follow the maintenance instructions contained in the manual of the machine in which the motor pump
is integrated or that of any combustion engine fitted to the machine.
• All maintenance jobs must only be performed after carrying out the operations described in the
32
CLEANING AND DECOMMISSIONING

MAINTENANCE

STOP
"o " paragraph.
peratIon
" paragraph carefully.
"S " paragraph,
top
"S "
top