Programming Help For Lokmaus 2 /R3 - Multimaus - roco multiMAUS PRO Handbuch

The readout of the decoder data ("PROGRAM"
menu) triggers the message "NO CONFIRMA-
TION" in the display.
POM mode: Programming is confirmed,
but the decoder does not react to an altered value
Resetting (Part 3, Chapter 3.3, page 76) of the
multiMAUS is not possible.
PRO
The Turnout reacts incorrectly or the turnout set-
ting does not match display
Display shows OFFLINE
5.8.1 Programming Help for Lokmaus 2 /R3 – multiMAUS
Previous operating manuals for digital ROCO articles (e.g. 42624 turnout drive) only describe the standard program-
ming mode for Lokmaus 2 /R3. The following includes a table which compares the programming procedure for the
Lokmaus 2 /R3 and quick programming (see chapter 2.8 on page 64) on the multiMAUS
For more information see the operating manual for the Lokmaus 2 /R3. To program CV29 see the operating instruc-
tions included with the decoder.
CV
1 – Address
2 – Minimum speed
3 – Start-up delay
4 – Braking delay
5 – Maximum speed
29 – Decoder settings
Change speed steps
The decoder cannot be read out.
▪
The multiMAUS
▪
item 2.5, page 73).
Contact problems of the locomotive on the track?
▪
Decoder needs to be reset: Switch the track voltage off
▪
and back on again using the "STOP" key (emergency
stop). See the operating manual for the decoder.
Press the "shift" and "MENU" keys simultaneously and
▪
press the "Light/OK" key briefly. The display lights up
briefly.
This resets the multiMAUS
▪
settings. A reset also deletes the locomotive library and
should therefore only be carried out if absolutely neces-
sary.
Turn the plug on the turnout drive.
▪
The selected action needs a radio connection with the
▪
multiZENTRALE
OFFLINE is showed.
PRO
multiMAUS
PRO
+
+
+
+
+
Can only be programmed in menu
mode (see page 73)
+
/
is set to "POM" mode (Part 3, menu
PRO
completely to the factory
PRO
. If this connection does not exist
PRO
.
PRO
Lokmaus 2/R3 (for comparison)
+
+
+
+
+
+
+
/
87