Short Circuit And Overload - roco multiMAUS PRO Handbuch

Input
You can also program new values for CV 2, 3, 4 and 5 as shown in this example. To do so, you simply press the
"Menu" key together with the "function key" with the number corresponding to the CV and then proceed as in
the above example.
If you set value "8" in CV8 (no other value is necessary), all CVs of the decoder are reset to factory values. Since
this procedure is not supported by all decoders, you should consult the decoder's manual for additional infor-
mation.
If you experience programming problems, please read Part 3 "Menus" or the Chapter "Tips, Information, and
Shortcuts" in Part 5 for additional help.

2.9 Short Circuit and Overload

If a system short circuit or overload occurs, the ROCO digital system indicates
this in two different ways. Two symbols flash in the display of the multiMAUS
namely a lightning or thunderbolt symbol and the STOP sign. The red LED
flashes on the multiZENTRALE
nected at the same time.
If there is a short circuit, e.g. because of a derailed coach or train, eliminate the
fault.
Press the „STOP" key of the multiMAUS
on with a delay of approx. one second.
If the fault is not a short circuit, the cause may be an overload of the system due to the simultaneous operation
of too many locomotives. If this occurs frequently, the power supply to your system is insufficient. This is fixed
by connecting an additional booster (Part 5 "The Booster 10765", page 84). Never use a normal transformer con-
nected directly to the power supply input since this may destroy the multiMAUS and/or the multiZENTRALE
Display message Comment
Press one of the function keys to overwrite the dis-
played CV value. The insertion point flashes.
Confirm by pressing "OK". The multiMAUS
to train operation after the last display ("C 1").
Note: After checking the CV1 of a locomotive, check
whether the address information of the locomotive
in the locomotive library is still correct.
. The power supply to the system is discon-
PRO
or the white key of the multiZENTRALE
PRO
returns
PRO
,
PRO
to switch the system back
PRO
.
PRO
65