Start; First-Time Use; Already Used Multimaus Pro; Selecting A Locomotive - roco multiMAUS PRO Handbuch

Part 2
Despite its numerous options, operation of the multiMAUS
been successfully introduced for the Lokmaus models of the first and second generation. The following shows you
how to operate the multiMAUS
"Tips, Information, and Shortcuts" can be found starting on page 86.

2.1 Start

After starting up the multiMAUS
The multiMAUS then switches to drive mode and displays the first locomotive.
PRO

2.1.1 First-time use

When connecting the multiMAUS
tive (address 3) in the library ("library mode" factory setting). The display screen
shows the locomotive symbol, the standstill symbol "II" (i.e. the locomotive is
stopped) together with the right arrow and the lettering "LOCO 1" so that you can
drive the locomotive immediately.
If you have purchased the multiMAUS
the set is already fully programmed. You can also drive this locomotive immediately
(chapter 2.3).
2.1.2 An already used multiMAUS
If you have already used the multiMAUS
the library or the address mode.
While scrolling with the "arrow keys" you see all settings of the traction operations, i.e. drive direction, name
or address of the locomotive, selected functions.

2.2 Selecting a Locomotive

The multiMAUS offers two ways of selecting a locomotive:
PRO
With the library mode set at the factory: see the following Chapter 2.2.1.
▪
With the address mode, i.e. using the locomotive address directly: see Chapter 2.2.2.
▪
Switching between library and locomotive address mode

2.2.1 Library mode

Locomotive library mode is a database which gives you the option of saving 64 locomotives with a name (5
characters), locomotive address and the required speed steps.
The decoder locomotive address therefore always has to be changed using "CV1" (see 2.8 "Quick-program-
ming" on page 64). You will be required to make the changes in the library as well.
Screen display (in this case an "ICE"-train of the second series):
Locomotive name (in this case "ICE-2") and loco symbol,
▪
Direction of travel (in this case: the locomotive was or is stopped, the arrow
▪
shows the last direction of travel),
Light (in this case: the locomotive lighting is switched on),
▪
F1 and F4 (in this case: the activated locomotive functions).
▪
Operation – Driving and Switching
▪
based on practical examples. If problems occur during operation or programming,
PRO
, the display screen shows the word "MULTIMAUS" in animated lettering.
PRO
for the first time, there is only one locomo-
PRO
with a starter set, the locomotive from
PRO
PRO
, the locomotive last controlled is displayed – regardless if you used
PRO
is simple and intuitive. A concept which had already
PRO
+
53