Selective Locomotive Stop; Double Heading; Setting Up Double Heading - roco multiMAUS PRO Handbuch

2.4.2 Selective Locomotive Stop

The selective locomotive stop only stops the locomotive currently being controlled by the multiMAUS
Input
The locomotive stop is released by turning the controller, the locomotive starts to move again.

2.5 Double Heading

The new ROCO digital system also allows for double heading, which means controlling two locomotives in front
of a train. Two locomotives are coupled and can be controlled centrally at once from one of the two locomotive
addresses.
Use the multiMAUS
motives can be driven only in one double heading.
2.5.1 Setting up a Double Heading
A new double heading is easy to set up from the respective locomotive control mode with just a few key com-
binations:
Input
/
/
58
58
Display message
to set up a max. of 8 double headings each with two locomotives. Each one of the loco-
PRO
Display message
Comment
Press the "Shift" and "STOP" key at the same time.
The locomotive stops immediately, the standstill
symbol "II" (and the last direction of travel) is shown
on the display screen.
Note: This type of emergency stop is only indicated
by the last direction if an additional Lokmaus 2 or R3
with lights is connected.
Comment
Select the first locomotive of the double heading
from the locomotive library or via the locomotive
address using the arrow keys. The double heading is
then created either in library (as with our example)
or address mode.
Our example shows the selected locomotive is the
"BR215."
Then press the "MENU" key together with the
"Function Key 0". This selects the first locomotive.
Any function and drive symbols are not depicted.
Select the second locomotive with the arrow keys. In
our case, this is a diesel locomotive labeled "TAIGA".
Again, function and drive symbols are not depicted.
Confirm with "OK".
.
PRO